Automatically setting Traceability values

For any one Traceability, GS uses this order of precedence* to set Traceability values for a data record:

Applies to: GS will store the traceability set here: If these conditions are met:

1

Inspections

Test Specific Traceability on a Data Test**

This field is not left blank when Sub-inspection is Submitted.

(If true, all methods below are ignored.)

2

Inspections

Traceability Test on the same Sub-inspection as a Data Test**

This field is not left blank when Sub-inspection is Submitted.

(If true, all methods below are ignored.)

3

Inspections,
Quick Data Entry

Traceability Test on the Inspection Data panel

This field is not left blank when Sub-inspection is Submitted.

(If true, all methods below are ignored.)

4

Inspections,
Quick Data Entry

User who Submits the data

This Traceability is preset for the User.

(If true, all methods below are ignored.)

5

Inspections,
Quick Data Entry

Workstation that Submits the data

This Traceability is preset for the Workstation.

(If true, all methods below are ignored.)

6

Inspections,
Quick Data Entry

Characteristic for which data is Submitted

This Traceability is preset for the Characteristic.

(If true, all methods below are ignored.)

7

Inspections,
Quick Data Entry

Process for which data is Submitted

This Traceability is preset for the Process.

* This does not apply when importing or exporting data, setting defect-specific traceability, or setting value-specific traceability.

** Data Tests include SPC measurement, Pass/Fail, Defect List, Rating, Task, and OEE. Each data Test creates a data record when submitted.